EMC QLogic Installation Guide download pdf (Page 108)

108

EMC Host Connectivity with QLogic FC and iSCSI HBAs and FCoE CNAs for the Linux Environment

Installing and Configuring the Linux Host with the QLogic Driver

Preinstallation instructions

Prior to the installation:

◆ All I/O must be stopped.

◆ All filesystems attached to the QLogic driver must be

unmounted.

◆ If the Naviagent/CLI is installed and enabled on the host, then

the Naviagent/CLI service must be stopped.

To stop the Naviagent/CLI service, issue one of the two following

commands:

/etc/init.d/naviagentcli stop

service naviagentcli stop

If PowerPath is installed and enabled on the host, then the PowerPath

service must be stopped.

To stop the PowerPath service, issue one of the two following

commands:

/etc/init.d/PowerPath stop

service PowerPath stop

If the QLogic SANsurfer daemon

iqlremote is installed and enabled

on the host, then the

iqlremote service must be stopped in order for

the driver to be removed from the currently running kernel.

To stop the

iqlremote service, issue one of the two following

commands:

/etc/init.d/iqlremote stop

service iqlremote stop

Downloading the QLogic v5.x-Series iSCSI driver for the v2.6.x kernel

Use the following procedure to download the EMC-approved QLogic

iSCSI driver from the QLogic website:

1. Use a web browser to access the EMC-approved section of the

QLogic website at the following url:

http://www.qlogic.com

2. Select the appropriate link from the EMC-approved section of the

QLogic website:

EMC CLARiiON, EMC Symmetrix & EMC Celerra supported

software

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 215 216

No comments

EMC QLogic Installation Guide Page 108