EMC QLogic Installation Guide download pdf (Page 144)

142

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Troubleshooting

Solution Upgrade to the latest HBA driver. This was corrected for Windows

2000 in 8.2.2.25 and later drivers. Windows 2003 driver 8.2.2.20 and

later already contain this correction.

Problem 4

EMC Knowledge base solution emc69308 — Direct-connect to EMC

CLARiiON CX200 reports incorrect queue full error messages. Even

under light I/O, a host may log a message noting that disk has

reached a queue-full state similar to the following in the Windows

event viewer:

Event ID: 11

Source: ql2300

Description: The driver detected a controller error on \Device\Scsi\ql2300x.

Data (words): offset 34 = F003001C [ErrorCode: Target device queue full].

Solution Upgrade to the latest HBA driver. This was corrected in version

8.2.2.25 and later drivers.

Problem 5

Windows 2000 hosts running less than SP4 could be susceptible to

data loss during LUN expansion operations.

Solution This issue is corrected by Microsoft in SP4, or by applying hot fix

327020. Refer to EMC Knowledge base solution emc73538 and

Microsoft Knowledge Base article 327020 for more information.

Problem 6

For Windows 2003, the STORPort drivers 8.2.3.26 with Microsoft

hotfix Q823728 and earlier do not yet fully support all Microsoft VSS

functions.

Solution This was first corrected in Microsoft QFE hot fix Q837413 and to be

used with minimum 8.2.3.27 driver. You should also use minimum

Microsoft VSS QFE 833167.

1 2 ... 139 140 141 142 143 144 145 146 147 148 149 150

No comments

EMC QLogic Installation Guide Page 144