96
EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment
Miscellaneous Planning and Procedures
◆ To configure your iSCSI targets, click the Target Settings tab from
the SANsurfer iSCSI HBA Manager dialog, as shown in
Figure 72.
Figure 72 SANsurfer iSCSI HBA Manager, Target Settings tab
◆ To add your target, click the green + on the right side of the Targ e t
Settings tab to get the IP Address dialog, as shown in Figure 73.
Enter the IP address of your target port, and click OK.
Figure 73 SANsurfer iSCSI HBA Manager, Target Settings, IP Address dialog
Comments to this Manuals