EMC QLogic Installation Guide download pdf (Page 50)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

The utility reports that it is done saving changes

20. Press any key to continue, and then 12 to exit the utility.

The system reports that options have been set, as shown in

Figure 32.

Figure 32 Options set

21. Press Enter to return to the EFI shell. Type reset to reboot the

server to enable the changes.

22. Following the reboot, open the EFI shell. The Device Mapping

Ta bl e may be listed by default (similar to Figure 19 on page 37).

a. If the Device Mapping Table is not listed, type map and press

Enter.

Figure 33 Example blkD as array port

b. Note any entries starting with blk (block-level devices, such as

volumes) which reference a Fibre interface (as shown in

Figure 33). The entry should list the array port WWN and

LUN address specified in the configuration utility. Figure 33

shows entry blkD as the array-port WWN and LUN specified

during configuration. This is the EFI entry that specifies the

specific array LUN to use for boot.

Note: The example shown in Figure 33 also shows BlkC as Lun0.

This is a Symmetrix

-based, read-only Volume Logix Database

device used for LUN masking and cannot be used for boot, even

though it is still detected by the QLogic EFI driver and is reported as

visible.

At this point, the OS installation can begin using this LUN as the boot

volume.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 149 150

No comments

EMC QLogic Installation Guide Page 50