EMC QLogic Installation Guide download pdf (Page 42)

EMC Fibre Channel and iSCSI with QLogic Host Bus Adapters in the Windows Environment

Installation and Configuration

Figure 22 Fibre Channel Card Efi utility

The QLogic HBA(s) installed in the server will be listed (as shown in

Figure 22). Note the "firmware" version listed in the utility. If the

firmware is listed as a specific version (not a series of zeroes), and

"AUX" is not listed next to the firmware field at the top of the report

then the EFI driver and firmware have been loaded on the HBA(s);

proceed to the section immediately following Figure 25 on page 43.

If the firmware is listed as a series of zeros, and "AUX" is listed next to

the firmware field at the top of the report (as shown in Figure 22), this

indicates the EFI boot code has not yet been installed on the HBA(s).

Proceed as follows:

To install the EFI boot code driver and non-volatile RAM settings on the

HBA(s):

The EFI boot code driver must be loaded onto the HBA(s) in order to

be used by the EFI BIOS.

1. Type update.nsh <qxxxxxxx.bin>, inserting the name of the EFI

boot driver package (bin file). The update procedure with run and

appear similar to the output showin in Figure 22.

2. Press Enter.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 149 150

No comments

EMC QLogic Installation Guide Page 42